Omron 3G3MV-PDRT2, User Manual

Page: 278 / 363

Chapter 10
10-20
Appendices
Note 1. The Net Reference and Reference From Net functions cannot be changed during running.
Note 2. Under the DeviceNet protocol, the unit for the speed reference is always r/min. The number
of motor poles (2 to 39) must be set in parameter n035/o1-03 (frequency reference setting
and display units) when using DeviceNet (open network). After changing the unit setting,
turn the power OFF and then ON again.
Note 3. Cannot be changed during running.
01 17 Current scale Current data unit selection
can be set and read. The
current data unit value is
calculated as follows:
Unit = 0.1 [A] x 1/2
b
b: Current scale set value
Set a negative value as its
2's complement.
−
15 to 15 (F1
to 0F hex)
00 Yes Yes Byte
1A Power scale Power data unit selection
can be set and read. The
power data unit value is cal-
culated as follows:
Unit = 1 [W] x 1/2
c
c: Power scale set value
Set a negative value as its
2's complement.
−
15 to 15 (F1
to 0F hex)
00 Yes Yes Byte
1B Voltage scale Voltage data unit selection
can be set and read. The
voltage data unit value is
calculated as follows:
Unit = 1 [V] x 1/2
d
d: Voltage scale set value
Set a negative value as its
2's complement.
−
15 to 15 (F1
to 0F hex)
00 Yes Yes Byte
1C Time scale Time data unit selection
can be set and read. The
time data unit value is cal-
culated as follows:
Unit = 1 [ms] x 1/2
e
e: Voltage scale set value
Set a negative value as its
2's complement.
−
15 to 15 (F1
to 0F hex)
00 Yes Yes Byte
1D Reference From
Net 00: Reference other than
DeviceNet (n004/b1-01)
01: Operating with
DeviceNet. --- 00 Yes No Byte
64 Electric power Average power value (W) --- 0000
0000 Yes No Long
65 Electric power
time scale Power value measurement
period (T) (reflected when
power is turned ON)
00: 10 minutes
01: 30 minutes
02: 60 minutes 00 to 02 00 Yes Yes Byte
6F Specific alarm Alarm code of the alarm or
minor fault detected in the
Inverter. For more details,
refer to
8-5 Inverter Alarms .
--- 0000 Yes No Word
70 Specific error Fault code of the fault
detected in the Inverter. For
more details, refer to
8-4
Inverter Faults .
--- 00 Yes No Byte
Instance Attribute Name Content Setting range Default Read Write Size