Omron 3G3MV-PDRT2, User Manual

Page: 360 / 363

Chapter 10
10-102
Appendices
Note 1. Values in parentheses are for 400-V-class Inverters.
Note 2. The default setting depends upon the type of Inverter. The value for a 200-V-class 0.4-kW
Inverter is given above.
■
Operator Parameters
Note The default setting depends upon the type of Inverter. The value for a 200-V-class 0.4-kW
Inverter is given above.
L8-05 04A8 01 BC Input open-phase protection selection 0, 1 1 0 No
L8-07 04AA 01 BD Output open-phase protection selec-
tion 0, 1 1 0 No
L8-10 04AD 01 BE Ground fault protection operation
selection 0, 1 1 1 No
L8-17 04B4 --- --- Low-speed carrier frequency reduction
selection (2) 0 to 3 1 1 No
L8-19 04B6 --- --- Low-speed Inverter overload (OL2)
characteristic selection 0, 1 1 0 No
Con-
stant
Regis-
ter num-
ber
(hex)
Class 64 (hex) Name Setting
range
Setting
unit
Default
setting
Write
during
opera-
tion
In-
stance
At-
tribute
o1-01 0500 01 BF Monitor selection 4 to 38 1 6 Yes
o1-02 0501 01 C0 Monitor selection after power-on 1 to 4 1 1 Yes
o1-03 0502 01 C1 Frequency reference setting and dis-
play units 0 to
39999 1 0 No
o1-04 0503 01 C2 V/f pattern setting units 0, 1 1 0 No
o1-05 0504 01 C3 Not used. --- --- 0 ---
o2-01 0505 01 C4 Local/Remote Key 0, 1 1 1 No
o2-02 0506 01 C5 Stop Key 0, 1 1 1 No
o2-03 0507 --- --- User constant initial values 0 to 2 1 0 No
o2-04 0508 01 C6 Inverter capacity selection 0 to FF
(See
note.) 1 0 (See
note.) No
o2-05 0509 01 C7 Frequency reference setting method 0, 1 1 0 No
o2-06 050A 01 C8 Operation selection when Digital Oper-
ator is disconnected 0, 1 1 0 No
o2-07 050B --- --- Cumulative operation time setting 0 to
65535 1 hr 0 No
o2-08 050C --- --- Cumulative operation time selection 0, 1 1 0 No
o2-09 050D 01 C9 Factory use --- --- 1 ---
Con-
stant
Regis-
ter num-
ber
(hex)
Class 64 (hex) Name Setting
range
Setting
unit
Default
setting
Write
during
opera-
tion
In-
stance
At-
tribute