Maxsine EP3 AC Series, User Manual

Page: 59 / 246

4.1 Trial running with no load
49
4.1.2 Trial running in JOG mode
1. Turn on power supply
Turn on the control power supply (while the main power supply temporarily turned off).
The front panel display is lit. If any error appears, please inspect the wirings. Then turn on the
main power supply, the POWER indicating LED is lit.
2. Parameter setting
Set parameters according to the following table:
Paramet
er
Name Setting
value
Default
value
Parameter explanation
P004 Control mode 1 0 Set speed control
P025 Source of speed
command 3 0 Set JOG source
P060 Acceleration time of
speed command suitable 0 Decrease acceleration impact
P061 Deceleration time of
speed command suitable 0 Decrease deceleration impact
P076 JOG running speed 100 100 JOG speed
P097 Neglect inhibition of
servo driver 3 3 Neglect CCW inhibition
(CCWL) and CW inhibition
(CWL).
P098 Forced enable 1or 0 0 Set ‘1’for forced enable;
Set ‘0’for external enable.
P100 Digital input DI1
function
1 1 Set DI1 for servo enable (SON)
3. Operation
Confirming that there is no alarm and any unusual situation, turn on the servo enable (SON),
the RUN indicating LED lit and the servomotor is active at zero speed.
Choose the JOG running "
A-JOG
" in the auxiliary function. Pressing the button
5
to enter
the JOG running mode. The symbol of JOG is “ J ”, and the unit is r/min. The speed command is
provided by the button. Pressing down and hold the button
8
, the servomotor will rotate in
counterclockwise direction with the JOG speed. Loosen the pressed button, the servomotor stops
and keeps zero speed. Alternatively, pressing down and hold the
2
button, the servomotor will
rotate in clockwise direction with the JOG speed. The JOG speed is provided by P076 parameter