Kia Cerato 2021, Manual

Page: 542 / 714

What to do in an emergency
18 7
If you have a flat tyre (with spare tyre)
9. Loosen the wheel nuts and
remove them with your fingers.
Slide the wheel off the studs and
lay it flat so it cannot roll away.
To put the wheel on the hub, pick
up the spare tyre, line up the
holes with the studs and slide the
wheel onto them.
If this is difficult, tip the wheel
slightly and get the top hole in the
wheel lined up with the top stud.
Then jiggle the wheel back and
forth until the wheel can be slid
over the other studs.
WARNING
Wheels may have sharp edges. Han -
dle them carefully to avoid possible
severe injury. Before putting the
wheel into place, be sure that there
is nothing on the hub or wheel (such
as mud, tar, gravel, etc.) that inter
-
feres with the wheel from fitting
solidly against the hub.
If there is, remove it. If there is not
good contact on the mounting sur
-
face between the wheel and hub,
the wheel nuts could come loose
and cause the loss of a wheel. Loss
of a wheel may result in loss of con
-
trol of the vehicle. This may cause
serious injury or death.
10.To reinstall the wheel, hold it on
the studs, put the wheel nuts on
the studs and tighten them finger
tight. Jiggle the tyre to be sure it
is completely seated, then tighten
the nuts as much as possible with
your fingers again.
11.Lower the vehicle to the ground
by turning the wheel nut wrench
counterclockwise.
Then position the wrench as shown
in the drawing and tighten the
wheel nuts. Be sure the socket is
seated completely over the nut. Do
not stand on the wrench handle or
use an extension pipe over the
wrench handle. Go around the wheel
tightening every other nut until
they are all tight. Then double-
check each nut for tightness. After
changing wheels, have the system
checked by a professional workshop.
Kia recommends to visit an
authorised Kia dealer/service part
-
ner.
OBD061029L