![background image](http://html1.mh-extra.com/html/jabiru/j450/j450_constructors-manual_3129834084.webp)
Jabiru J450 Constructors Manual
Pre-Paint>Fuselage>Fit control cables and lines
Tuesday, April 6, 2010
84 of 343
Clamp the elevator cable into place using the
supplied clamp bracket, taking care to fit the
pressed locating section of the clamp in the
groove around the outer cable. The clamp
consists of a saddle and a backing plate, and
the whole clamp must be fitted onto a tapered
profile plate with the thin end of the wedge
facing the rear of the aircraft and secured to
the fuselage by 2 x AN3-6A bolts and Nyloc
nuts. Tighten firmly.
Fit the rudder cable
Feed the rudder cable (tagged end first) into
the slot on the right hand side of the fin stub,
then down though the front hole in the
empennage as shown at top right and forward
into the lower longitudinal rib through the
rubber grommet on the top of the rib as
shown at centre right.
You may need to use a wire hook through the
access hole behind the front seats to lift the
bundle over the main gear hump.
Keep feeding it in until it can be seen near
the rudder slot on the left-hand side of the
lower console as shown at lower right, then
use a hook to pull it through the slot and pull
it about 150mm though and into the cabin
footwell.
This completes the
Pre-Paint>Fuselage>Fit control cables and lines
task.
Fin stub
Console
Lower
longitudinal
rib
Floor