
Jabiru J450 Constructors Manual
Post-Paint>Fuselage>Fit doors
Tuesday, April 6, 2010
269 of 343
Fit the door locks
Fit the door locks though the lock holes in the fuselage behind
each door and fix in place with the retaining nuts. Tighten
each retaining nut firmly.
Fit the locking arm to the end of the shaft with the supplied
screw: apply a drop of Loctite 242 to each screw.
Check that the locking arm works in the correct sense and that
the key can be removed at both the locked and unlocked
positions. It may be necessary to lengthen the slot slightly if
the key cannot be removed in the locked position.
Clean the windows
Now you can clean the windows: start with a small
amount of methylated spirits on a clean cloth and
carefully remove any dust and debris from the painting
process then, using a clean soft cotton cloth, polish both
sides of each window with a good quality cleaner such
as
Novus Plastic Polish
: start with
Novus
#2 and then
finish with
Novus
#1.
Novus
#3 should only be used for
buffing out extremely heavy scratches.
Support an open door with one hand while you polish
the window.
Any cleaner/polish used must be safe to use on acrylic and must not contain any silicon.
This completes the
Post-Paint>Fuselage>Fit doors
task.