![background image](http://html1.mh-extra.com/html/jabiru/j450/j450_constructors-manual_3129834215.webp)
Jabiru J450 Constructors Manual
Post-Paint>Fuselage>Assemble instrument panel
Tuesday, April 6, 2010
215 of 343
Fit digital wiring harnesses
The digital wiring harnesses can now be fitted to the plugs at the rear of the digital
instruments and the VHF radio, transponder and intercom. Tighten the plug screws by hand.
There is an MP3 player input socket on the intercom harness and this may now be fitted to the
panel if desired. Select a location on the panel where the cable to the MP3 player will not
obscure any instruments and drill a 6mm hole through the panel and mount the socket.
Use zip ties to hold the digital harnesses to the wiring loom.
Tube up to the pressure instruments
Fit the nylon fittings to the rear of the pressure instruments – decide first where the static
tubing will run and use elbows and tees to suit. Take care not to cross-thread the nylon
fittings. Run the static tubing as required and leave it about 200mm below the bottom of the
panel. Run the pitot tubing from the ASI and trim to the same length. Mark the pitot tubing
clearly so that it will not be mistaken for the static line.
Zip tie the pressure tubes lightly (do not crush them) to the wiring loom.
This completes the
Post-Paint>Fuselage>Assemble instrument panel
task.
Standard
Jumbo