
Jabiru J450 Constructors Manual
Pre-Paint>Fuselage>Interior>Fit aileron cable brackets
Tuesday, April 6, 2010
135 of 343
Attach the aileron cable brackets
Sand the back of each aileron cable bracket as well as the
positions on the seat backs where they will be placed.
Clean all surfaces to be joined.
Prepare a small mix of resin and use a brush to undercoat the
positions on the seat backs where the aileron cable brackets will
be placed.
Working from the front of the seat, place all of
the rivets through the holes in the seat backs.
Add flock to the resin and apply an even layer of flock
approximately 2-3mm thick to the back of each aileron
cable bracket.
Working on one bracket at a time, place the bracket onto the rivets, then fit a washer over the
bottom rivet and hold it in place while using the rivet gun to secure the rivet. Repeat the
process with the top outside and top inside rivets.
Using a little resin on a clean mixing stick, clean any squeezed-
out flock from the brackets.
This completes the
Pre-Paint>Fuselage>Interior>Fit aileron
cable brackets
task.