
Jabiru J450 Constructors Manual
Post-Paint>Fuselage>Interior>Fit console controls
Tuesday, April 6, 2010
237 of 343
Post-Paint>Fuselage>Interior>Fit console controls
Objectives of this task:
To fit all of the console controls: the control stick, elevator trim and brake system.
Materials required:
Card # J17 „
Elevator System and Control Stick
‟
Card # J8 „
Dual Brakes
‟
Card # J2 „
Trim System
‟
Control stick
Fit the 2 eccentric aileron stops to the rear end plate
with 2 Allen head cap screws as shown at right.
The control stick should still be partly assembled from
the
Pre-Paint>Fuselage>Interior> Console>Fit
Control Stick
task. Clean any debris from the front and
rear bushes and apply a small amount of lubricant to the
bushes. Fit the control shaft into the console from the
front, wipe away any lubricant from the rear of the
control shaft and fit the aileron bellcrank to the rear of
the shaft with an AN3-16A bolt and Nyloc nut, with the
bolt fed up through the bellcrank.
Refer to the drawing on the next page for detail.
Fit the control stick to the pivot plate with an AN3-13A bolt, taking care to fit a flat nylon
washer on each side between the stick and the plate. Connect the elevator cable rod end to the
control stick with an AN3-21A bolt, spacer, 1/4” flat washer and a Nyloc nut as shown in the
photo above and in the drawing on the next page.
Check for full and free movement of the control stick.