
Jabiru J450 Constructors Manual
Post-Paint>Fuselage>Interior>Engine control cabling
Tuesday, April 6, 2010
257 of 343
Carb heat
Run the outer cable through the clamp and secure by tightening the
clamp, then slip the brass ferrule over the inner cable.
Make sure that the air valve drive arm is fully forward and then fit the
ferrule into the hole in the drive arm. Bend the inner cable at right
angles in front of the ferrule. Cut the excess inner cable off. Slip the
ferrule through the retaining collar and fit to the to the drive arm with a
washer and split pin fitted to the brass ferrule on the underside of the
drive arm.
Adjust the Carb Heat cable with the clamp until with the Carb Heat “T”
handle all the way in the air valve drive arm is fully forward as shown
above. Tighten the clamp bolts firmly.
Cabin heat
Put 1 lock nut on the threaded end of the Cabin Heat cable and fit it up
through the hole in the firewall beside the Cabin Heat valve. Fit the
other lock nut, fixing the threaded cable end through the firewall.
Make sure that the Cabin Heat valve drive arm is fully forward and then fit the ferrule into the
hole in the drive arm. Bend the inner cable at right angles in front of the ferrule. Cut the
excess inner cable off. Slip the ferrule through the retaining collar and fit to the to the drive
arm with a washer and split pin fitted to the brass ferrule on the underside of the drive arm.
Adjust the Cabin Heat cable until with the Cabin Heat knob all the way in the Cabin Heat
valve is fully closed. Tighten the lock nuts firmly.
This completes the
Post-Paint>Fuselage>Interior>Engine control cabling
task.