![background image](http://html1.mh-extra.com/html/jabiru/j450/j450_constructors-manual_3129834124.webp)
Jabiru J450 Constructors Manual
Pre-Paint>Fuselage>Interior>Console>Pre-fit trim control
Tuesday, April 6, 2010
124 of 343
Align and fit the trim cable clamp
It is important that the
trim cable clamp
is accurately positioned against the left-hand side of
the console in a way that minimises any bending loads on the
trim cable
. The procedure is as
follows: with the
trim cable
in place and working from the left-hand side of the console, put a
rod end
fully onto the cable end: thread the
rod end
all the way onto the cable end, then bolt
the
rod end
to the left-hand
trim lever
as shown in the first photo below.
Push the
inner trim cable
all the way into the
outer cable
then put the
trim lever
against the rear
trim stop
as shown at
left. This is the correct position for the
outer cable
to be
secured by the
cable clamp
. Fit the
cable clamp
to the
outer
cable
and make sure that the
cable clamp
grips the
locating
groove
on the outer
cable (circled at right).
Position the
trim cable clamp
against the console in such a
way as to line the
trim cable
up with the
rod end
on the
trim
lever
and drill 2 x 3/16 holes through the
cable clamp packer
and into the side of the console as shown in the photo shown
below at right. Temporarily position with 2 x AN3 bolts.
Bond the
cable clamp packer
into place and leave to cure. Remove the aligning bolts. Fit the
cable clamp
shim
, the
trim cable
and the
cable clamp
and mount with 2 x AN3 bolts placed
from the inside of the console and secured with Nyloc nuts on the outside of the
cable clamp
.
Remove the
trim levers
,
pivot bolt
and
pivot shaft
and put aside for later fitting after painting
and upholstery have been completed.
This completes the
Pre-Paint>Fuselage>Interior>Pre-fit trim control
task.
Bolt to trim lever
packer
clamp
outer cable
locating
groove
outer
cable
inner
cable
Inner cable
Rod end