
Jabiru J450 Constructors Manual
Testing>Final inspection checklist
Tuesday, April 6, 2010
314 of 343
Controls
Rudder pedals
1
Rudder springs installed properly
2
Rudder stops lining up properly
3
2 x Pedal mount bolts secure (pushrod to pedals)
4
Rudder pedal keepers secure and correct
5
2 x ¼” and 4 x 3/16” bolts secure in bearing blocks
6
2 x ¼” bolts secure in pushrods (pushrod to nose leg yoke)
7
Check jam nuts on rod ends secure x 5
8
Check safety hole is within limits on rod ends x 5
9
Check rod end free play at full deflection, both directions
10
Rudder clear of fin channel. Rudder cannot bind on channel
Rudder cable
1
Anchor secure and correct position in clamp
2
Rod end secure in pedal with ¼” washer outside
3
Safety hole is within limits on rod ends
4
Jam nuts on rod ends secured
5
Rod end free play at full deflections, in both directions
6
Rudder pedal stops adjusted and secure:
rudder should move 98mm left and right from the 5mm offset centre mark
Trim
1
Trim levers (left and right) are secure
2
Lever pivot secure and split pin fitted through nut
3
Free play between left and right side levers not excessive
4
Friction correct and secure
5
Rod end secure
6
Safety hole is within limits on rod ends
7
Jam nuts on rod ends secured
8
Cable position in clamp correct and anchor secure
9
Operation full forward and full back trim
10
Spring not coil bound with elevator fully deflected up
11
Placard fitted to console top in correct sense