
Jabiru J450 Constructors Manual
Post-Paint>Fuselage>Interior>Fit upholstery 1
Tuesday, April 6, 2010
223 of 343
2.
Firewall – glue the 10mm foam layer to the firewall and then glue the fabric to the
foam. Cut around the ribs as required. Lower firewall – fit the fabric down and back
along the floor slightly and also over the rudder pedal mounts.
3.
Windscreen pillars and firewall surrounds. These areas are covered by several small
pieces that each cover a rib or brace.
Note
: the fuel tank wiring should be fitted inside the
front pillars before covering them. Refer to the
Install electrical wiring
task.
4.
Front sidewalls – cut out the vent openings after the panel has been fixed in place.
5.
Crossbeam (front and back) and middle sidewalls behind the front doors.
6.
Seat sides and base up to the bottom of the door sills.
7.
Seat backs – cut around the aileron cable brackets (circled in yellow) before fixing the
panel in place.
2
4
4
3
3
6
6
1
7
5
5
5
6
10