6. Position Data Edit W
indow
145
Error/warning display before data transfer
When transferring position data to the controller, the position data to be transferred is checked for
problems and if any of the data cannot be transferred (due to excessive speed, acceleration,
deceleration, etc.), applicable errors/warnings are displayed in a list.
Fig. 6.49 Position Data Error List
If an error is found in the position data to be transferred, the position data will not be transferred.
If the position data to be transferred only generates a warning, the warning screen appears.
Fig. 6.50 Warning Screen
Click Yes to transfer the position data.
Click No to cancel the transfer of position data.
(Note) The maximum number of errors/warnings displayed in the position error list is set on the
Environment Setup screen. [Refer to Fig. 15.5, “Environment Setup Screen.”]
Select the "Show errors only"
check box to show only errors.
Click "Hide" in the pop-up
menu to hide the error list.
Summary of Contents for IA-101-TT-USB
