IAI IA-101-TT-USB, Operation Manual

Page: 86 / 392

3. Menu W
indow
78
3.2 Explanation of the Commands
(1) File (F)
[1] New (N) Create new SEL data.
• Program (S) Open the edit window for creating a new program.
• Position (O) Open the edit window for creating new position data.
This menu item will become faint-colored and render the command
inoperable in the case of the SSEL, ASEL, and PSEL controllers in the
positioner mode.
• Symbol (Y) Open the edit window for creating new symbol data.
This menu item will become faint-colored and render the command
inoperable in the case of the SSEL, ASEL, and PSEL controllers in the
positioner mode.
• Coordinate System (D)
Open the edit window for the new coordinate system definition data.
• RC-axis Position Data (R)
Open the edit window for creating new RC-axis position data
(X-SEL-P/Q/PX/QX (PC software V7.2.0.0 or later) and
R/S/RX/SX/RXD/SXD controllers with gateway function)
* In the case of the X-SEL-P/Q/PX/QX (PC software V7.2.0.0 or later) and
R/S/RX/SX/RXD/SXD controllers with gateway function, “RC-axis Position Data File
(*.rpt)” can be loaded.
Fig. 3.10 Target Selection Window
The target selection window (Fig. 3.10) will be displayed to select the controller type and the number of axes
(required to select it only when position data is created).
* The created data can be saved only in the file formant according to the target selected here (refer to the list
of support models in the preliminary section of this manual).
[2] Open (O) Load data currently saved in a file.
(Note) In the case of the SSEL, ASEL, or PSEL controller in the positioner
mode, the program file or symbol file cannot be open. If the file is open,
the ABB File Type Error will be displayed.
Fig. 3.11 ABB File Type Error