HP Storageworks 8100 - enterprise virtual array, User Manual

Page: 37 / 408

3 Managing the MPX200 using HP
Command View EVA
This chapter provides instructions for setting up the MPX200 management port, Fibre Channel zoning,
HP Command View EVA discovery, setting up the iSCSI IP ports, and setting the date and time.
NOTE:
DMS and FCIP functionality are not completely configured using HP Command View EVA. See the
sections
Chapter 6 on page 139 and Chapter 5 on page 113 for configuration requirements.
Setting up the MPX200 management port
Most management functions have been built into HP Command View EVA. In some cases, access to
the MPX200 CLI is required.
You connect to the CLI through one of the following:
• RS-232 serial port (115200/8/n/1)
• Telnet
• Secure Shell (SSH)
By default, the management port obtains a Dynamic Host Configuration Protocol (DHCP) address. If
the management port cannot obtain a DHCP address, you must set a static IP address.
Fibre Channel zoning
Because the MPX200 is a fabric-connected device only, it is important to understand the zoning
requirements.
Open zoning
When using an open zone configuration, each FC port on each MPX200 must be connected to a
separate fabric, as shown in .
MPX200 Multifunction Router 37