HP Storageworks 8100 - enterprise virtual array, User Manual

Page: 108 / 408

hpstorageworks
General Tab Secret
hpstorageworks
iSCSI Port
CHAPsecret0
Add Target Portal
CHAPsecret01
Discovered iSCSI
Initiator
CHAPsecret01
Log on to Target N/A
iSCSI Presented
Target
NOTE:
These are examples of secret settings. Configure CHAP using settings that apply to your network
environment.
1. Enable CHAP for the MPX200 discovered iSCSI initiator entry (CHAP can be enabled via CLI
only).
a. If the iSCSI initiator is not listed when you execute the
set chap
command, do one of the
following:
• From HP Command View EVA, select Hosts , and then select the Add Host tab. Enter the
IQN name string.
• From the CLI, enter the
initiator add
command and add the iSCSI initiator that will
perform the discovery.
b. If the iSCSI initiator is listed under the
set chap
command, then enable CHAP secret (for
example:
CHAPsecret01
).
• Select the index of the iSCSI initiator.
• To Enable CHAP, select 0, and then enter the CHAP secret.
2. Enable CHAP for the MPX200 iSCSI port:
a. To enable CHAP for the MPX200 iSCSI port using HP Command View:
• Select the appropriate iSCSI Controller, then select the IP Ports tab, and then select the
appropriate IP Port.
• Under Security, select Enabled in CHAP Status, and then enter the CHAP Secret (for ex-
ample,
hpstorageworks
).
• Select the Save Changes tab to save the changes.
b. To enable CHAP for the MPX200 iSCSI port using the MPX200 CLI:
• Enter the
set chap
command.
• Select the appropriate Portal iqn name index that the initiator will log in to.
• Select 0 to enable CHAP.
• Enter a CHAP secret. For example:
hpstorageworks
.
MPX200 iSCSI configuration rules and guidelines 108