HP AE370A - Brocade 4Gb SAN Switch 4/12, Administrator'S Manual

Page: 74 / 447

74 Managing user accounts
12. In the Edit Dial-in Profile window, click the Authentication tab and check only the Encrypted
Authentication (CHAP) and Unencrypted Authentication (PAP, SPAP) checkboxes; then
click the Advanced tab and click Add .
13. In the Add Attributes window, select Vendor-Specific and click Add .
14. In the Multivalued Attribute Information window, click Add .
15. In the Vendor-Specific Attribute Information window, click the Enter Vendor Code radio button and
enter the value 1588 . Click the Yes. It conforms radio button, and then click Configure
Attribute... .
16. In the Configure VSA (RFC compliant) window, enter the following values and click OK .
Vendor-assigned attribute number—Enter the value 1 .
Attribute format—Enter String .
Attribute value—Enter the login role (Root, Admin, Factory, SwitchAdmin, or User) the user group must
use to log in to the switch.
17. In the Multivalued Attribute Information window, click OK .
18. In the Edit Dial-in Profile window, remove all additional parameters (except the one you just added,
“Vendor-Specific”) and click OK .
19. In the Add Remote Access Policy window, click Finish .
20. After returning to the Internet Authentication Service window, repeat steps 5 through 19 to add
additional policies for all login types you want to use the RADIUS server. After this is done, you can
configure the switch.
Configuring RADIUS servers on the switch
RADIUS configuration of the switch is controlled by the
aaaConfig
command.
NOTE: On dual-CP switches (SAN Director 2/128 and 4/256 SAN Director), the switch sends its
RADIUS request using the IP address of the active CP. When adding clients, add both the active and
standby CP IP addresses so that users can still log in the event of a failover.
The following procedures show how to use the
aaaConfig
command to set up a switch for RADIUS
service.
RADIUS configuration is chassis-based configuration data. On platforms containing multiple switch
instances, the configuration applies to all instances. The configuration is persistent across
reboot
and
firmwareDownload
. On a chassis-based system, the command must replicate the configuration to the
standby CP.
Multiple login sessions can invoke the command simultaneously. The last session that applies the change
be the one whose configuration is in effect. This configuration is persistent after an HA failover.