HP AE370A - Brocade 4Gb SAN Switch 4/12, Administrator'S Manual

Page: 399 / 447

Fabric OS 5.2.x administrator guide 383
CAUTION: After changing the fabric PID format, if the change invalidates the configuration data (see
Table 91 to determine this), do not download old (pre-PID format change) configuration files to any switch
on the fabric.
After changing the fabric PID format and verifying correct fabric operation, resave configuration data by
running the
configUpload
command.
Before downgrading firmware, change the PID back to supported PIDs such as Core PID. If the database is
automatically converted, save the converted database, and then download the older OS.
Selecting a PID format
All switches in a fabric must use the same PID format, so if you add a switch that uses a different PID format
to a fabric, the switch will segment from the fabric. The format you select for your fabric depends on the mix
of switches in the fabric, and to an extent on the specific releases of Fabric OS in use (for example,
Extended Edge PID format is only available in Fabric OS v2.6.2 and later, Fabric OS v3.1.2 and later, and
Fabric OS v4.2.0 and later).
If you are building a new fabric with switches running various Fabric OS versions, use Core PID format to
simplify port-to-area_ID mapping.
NOTE:
Switches that are queried using outside calls should be configured using PID 1 (core PID) to ensure
that the correct port numbering is used in other management applications.
Table 91 Effects of PID format changes on configurations
PID format
before change PID format after
change Configuration effect
Native Extended Edge No impact
Extended Edge Native No impact
Native Core You must:
• re-enable zoning, if there is an active zone set
and it uses port zones.
• You do not need to reconfigure Destination ID
(DID) if using:
• Performance monitoring
• The configure command to change the PID
format
• The performance monitor database
• The zoning database
• Security dcc database (if secure mode is
enabled)
The DID will be converted by Fabric OS automatically.
Core Native
Extended Edge Core
Core Extended Edge