HP AE370A - Brocade 4Gb SAN Switch 4/12, Administrator'S Manual

Page: 24 / 447

24 Performing basic configuration tasks
4. Enter the
password
.
The default password is:
password
If you have not changed the system passwords from the default, you are prompted to change them.
Enter the new system passwords, or press Ctrl-c to skip the password prompts. See ” How to change
default passwords at login ” on page 26.
5. Verify that the login was successful.
The prompt displays the switch name and user ID to which you are connected.
Using a console session on the serial port
Note the following behaviors for serial connections:
• Some procedures require that you connect through the serial port; for example, setting the IP address or
setting the boot PROM password.
• If secure mode is enabled, connect through the serial port of the primary FCS switch.
• SAN Director 2/128 and 4/256 SAN Director : You can connect to CP0 or CP1 using either of
the two serial ports.
How to connect via the serial port
1. Connect the serial cable to the serial port on the switch and to an RS-232 serial port on the workstation.
If the serial port on the workstation is RJ-45 instead of RS-232, remove the adapter on the end of the
serial cable and insert the exposed RJ-45 connector into the RJ-45 serial port on the workstation.
2. Open a terminal emulator application (such as HyperTerminal on a PC, or TERM, TIP, or Kermit in a
UNIX environment), and configure the application as follows:
• In a Windows environment:
• In a UNIX environment, enter the following string at the prompt:
tip /dev/ttyb -9600
.
If ttyb is already in use, you can use ttya (enter
tip /dev/ttya -9600
).
Setting the default account passwords
The switch automatically prompts you to change the default account passwords after logging in for the first
time. If you do not change the passwords, the switch prompts you after each subsequent login until all the
default passwords have been changed.
NOTE: The default account passwords can be changed from their original value only when prompted
immediately following the login only; the passwords cannot be changed using the
passwd
command later
in the session. If you skip the prompt, but later decide to change the passwords, log out and back in.
The default accounts on the switch are
admin
,
user
,
root
, and
factory
. Use the default administrative
account as shown in Table 4 , to log in to the switch for the first time and to perform the basic configuration
tasks described in this chapter.
login: admin
password: xxxxxxx
switch:admin>
Parameter Value
Bits per second 9600
Databits
8
Parity None
Stop bits 1
Flow control None