Hamilton Jet HTX30, Product Manual

Page: 103 / 182

HTX30 Product Manual Fault Finding
6-11
EIM alarms
Name SCP text Description Priority
Engine local
mode
LOCAL The operator has taken control at the engine local control panel Warning
SCP demand
lost
DEMND / LOST This module has lost in control demand from the SCPs Alarm
Gearbox
feedback
invalid
GBXFB The gearbox feedback lines are in an invalid combination Alarm
RPM feedback
invalid
RPMFB The engine is on and the RPM feedback is outside the engine RPM
range
Warning
Voltage
reference
invalid
VRFIN Ratiometric voltage reference is enabled but out of range Alarm
Actuator drive
fault
ACDRV The motor drive to the actuator has dropped out Alarm
RPM followup RPMFO The engine demand is stable but the engine has not followed up,
or it no longer matches demand
Warning
Throttle
actuator
shutdown
THRTL/ SHTDN The throttle has been returned to idle and the actuator has
disengaged due to not being able to meet the operators demand.
Subcodes:

0 - None

1 - OOR

2 - Pinched

3 - Stuck
Warning
Throttle
actuator stuck
Thrtl / stuck The throttle actuator could not move to the requested setting and
has stopped at a lower throttle
Alarm
CID alarms
Name SCP text Description Priority
Handle
connection
fault
HNDLE/FAULT The JETanchor Mouseboat cannot communicate with the handle
board
Alarm
Input out of
range
INOOR A input signal from a pot has gone out of range Alarm
XCI alarms
Name SCP text Description Priority
Control conflict CTRL / CNFLT More than one station is in control Warning
Cannot claim
address
ADDR / NOCLM At least one J1939 node could not claim an address Alarm