Hamilton Jet HTX30, Product Manual

Page: 13 / 182

HTX30 Product Manual System Overview
2-1
2 - System Overview
In this section
Installation and commissioning overview ............................................................................. 2-1
Component overview ............................................................................................................ 2-2
This manual describes the installation, configuration and commissioning of the blue ARROW control system.
It is intended for use by registered installers who have successfully completed the HamiltonJet blue ARROW
installation training course.
This control system is designed for use with single and twin-jet vessels only, with one or more control
stations.
Refer to www.hamiltonjet.co.nz for a list of supported configuration schemas. Over time, new schemas will
be developed to support additional configurations.
If a schema for your vessel configuration is not shown, please contact HamiltonJet for more information.
For instructions on how to operate the blue ARROW control system, refer to the user guide.
For information about the jet unit, refer to the jet unit installation and service manuals.
Installation and commissioning overview
HamiltonJet recommends that installation and commissioning are followed in the order shown in the table
below.
This will make sure that all precautions and tests have been done before final registration and transfer of
vessel to the end user.
A list of steps to be done during each stage of the installation can be found here (
► page 8-28).