Hamilton Jet HTX30, Product Manual

Page: 122 / 182

Appendix HTX30 Product Manual
8-8
Water offtake bungs and hose tails
Loctite Colour Primer, activator, accelerator Loctite cure speed
567
White Type Drying time Partial Full
Primer 7649 30-70 seconds With primer 2 hours 6 hours
(optional) Without primer 12 hours 24 hours
Water offtake bungs & hose tails (thread sealant).
Use accelerator where cure speed is unacceptably long.
1 - Apply optional accelerator to thread of plug or hose tail. Allow to dry.
2 - Do not apply accelerator to brass hose tails.
3 - Apply Loctite to thread engagement area of the plug or hose tail leaving the
first thread Loctite free.
Screw plug or hose tail into tailpipe until plug or hose tail bottoms and tighten
firmly.
Unpainted bores, D-glide bushes
Loctite Colour Primer, activator, accelerator Loctite cure speed
325
Amber Type Drying time Partial Full
Activator 7387, or
Activator 7075
1-3 minutes 5 minutes 24 hours
D-glide bush retention (high strength adhesive).
Use activator in all retaining applications.
Loctite 325 will not cure without the Activator.
1 - Apply a coat of activator to the outside surface of the bush. Allow to dry.
2 - Apply adhesive to whole surface of bore.

There are to be NO dry areas between the bush and the bore once assembled.

The bush must be pressed into the bore within 15 minutes.
Main shaft nuts without locking devices
Loctite Colour Primer, activator, accelerator Loctite cure speed
243
Blue Type Drying time Partial Full
Primer 7471 30-70 seconds With primer 10 minutes 2 hours
(optional) n/a Without primer 20 minutes 6 hours
Main shaft nuts (medium strength thread locking).
Use primer to shorten the cure time when the temperature is below 15°.
1 - Apply optional primer to the threads on the main shaft. Allow to dry.
2 - Apply Loctite to the thread engagement areas of the main shaft in sufficient
quantity to fill all engaged threads.
Assemble nuts to `jet specific' torque specifications.
Tailpipe fairings without locking devices
Loctite Colour Primer, activator, accelerator Loctite cure speed
680
Green
Type Drying time Partial Full
Primer 7471 30-70 seconds 5 minutes 4-6 hours
Tailpipe fairings without locking devices (extra high strength retaining).
1 - Apply primer to spigot of fairing. Allow to dry.
2 - Apply Loctite to spigot bore of tailpipe.
Fit using normal methods.