Hamilton Jet HTX30, Product Manual

Page: 123 / 182

HTX30 Product Manual Appendix
8-9
Nuts on studs and bolts (where specified)
Loctite Colour Primer, activator, accelerator Loctite cure speed
243
Blue Type Drying time Partial Full
Primer 7471 30-70 seconds With primer 10 minutes 2 hours
(optional) n/a Without primer 20 minutes 6 hours
222
Purple Primer 7471 30-70 seconds With primer 10 minutes 2 hours
(optional) n/a Without primer 20 minutes 6 hours
Nuts (low strength thread locking).
Use primer to shorten the cure time when the temperature is below 15°.
1 - Apply optional primer to the thread of the stud or bolt. Allow to dry.
2 - Apply Loctite to the thread engagement area of the stud or bolt in
sufficient quantity to fill all engaged threads.
Tighten nuts to the specified torque. Find tightening torques for fasteners
here ( ► page 8-13).
Tailpipe inserts (where fitted)
Loctite Colour Primer, activator, accelerator Loctite cure speed
263
Red Type Drying time Partial Full
Primer 7649 30-70 seconds With primer 10 minutes 2 hours
(optional) n/a Without primer 20 minutes 6 hours
Tailpipe inserts (high strength thread locking).
Use primer in all retaining applications.
1 - Apply primer to the thread of the insert. Allow to dry.
2 - Apply Loctite to the female threads in the tailpipe and the threads of the
insert in sufficient quantity to fill all the engaged threads.

There are to be no dry areas between insert and tailpipe threads.
Screw insert into the tailpipe until it bottoms. Tighten firmly.
Steel cylinders and AB2 frontheads
Loctite Colour Primer, activator, accelerator Loctite cure speed
542
Brown Type Drying time Partial Full
n/a n/a 45 minutes 24 hours
Steel cylinders and AB2 frontheads (medium strength hydraulic thread
sealant).
Leave the first thread free of sealant.
Force the sealant into the threads to thoroughly fill all threads.
1 - Apply Loctite to the leading threads of the cylinder (fronthead end only).
Assemble the fronthead to the cylinder and tighten firmly.