Hamilton Jet HTX30, Product Manual

Page: 164 / 182

Appendix HTX30 Product Manual
8-50
Sensors group
Short name: Sens
Name SCP text Description Min Max Default Units Access
JHPU oil temp OilT Maximum JHPU oil temperature, before an alarm
condition. Set to zero to disable the oil temperature
sensor
0 200 70 degC D
JHPU oil level OilL Enables the JPHU oil level sender 0 1 1 D
Bearing oil temp
switch
brgT Enables the bearing oil temperature switch detection 0 1 0 D
Jet RPM pulses per
rev
Jet / Rpm /
PPR
The number of pulses per rev the jet RPM senor will be
triggered per revolution, Set to zero to disable the jet
Rpm sensor
0 12 3 D
Jet RPM staggered Jet / Rpm /
Stagd
Enables staggered pulses on the jet RPM sensor, which
allows direction detection. This only works when the jet
RPM sensor is enabled
0 1 1 D
Backup group
Short name: Bkp
Name SCP text Description Min Max Default Units Access
Str Kp StrKp Overrides the automatic backup str kp control value. Set
to zero to use automatic value
0 100 0 C
Rev Kp RevKp Overrides the automatic backup rev kp control value.
Set to zero to use automatic value
0 100 0 C
Str Ki StrKi Overrides the automatic backup str ki control value. Set
to zero to use automatic value
0 100 0 C
Rev Ki RevKi Overrides the automatic backup rev ki control value. Set
to zero to use automatic value
0 100 0 C
Eng Dmd Mode Eng / Mode The backup engine dmd interface mode:

Vo - Voltage

Cu - Current

ID - Increment/Decrement

Pl - PWM voltage

Pd - PWM open drain

Pp - PWM open drain w/pullup
C
Eng Dmd High Eng / High The backup eng dmd high value 0 16383 16000 C
Eng Dmd Low Eng / Low The backup eng dmd low value 0 16383 100 C
Eng Dmd A EngA The backup eng dmd A value 0 16383 0 C
Eng Dmd B EngB The backup eng dmd B value 0 16383 0 C
Eng Dmd Invert Eng / Inv Inverts the engine dmd output 0 1 0 C