Hamilton Jet HTX30, Product Manual

Page: 62 / 182

Commissioning HTX30 Product Manual
5-20
Set the following waterjet parameters:
These parameters must be set to match each individual vessel. JETanchor will not function correctly
if the default values are used.
Parameter Description
Jet model The model of waterjet being set up.
Jet X offset Set the fore/aft distance of the waterjet thrust points from the vessel's
origin. Measurement is in mm, expressed as a negative. Waterjet offset is
shown in the figure later in this section.
Jet spacing The distance between waterjet main shafts. Measurement is in mm.
Impeller rating Measurement is in W*100.
Deadrise Measurement is in milli-degrees.
Maximum JETanchor RPM The maximum mainshaft rpm that JETanchor can demand.
Maximum RPM This must be the maximum main shaft rpm at full engine speed.
Set the waterjet parameters.
For an explanation of Jet X offset, see the following
figure.
Click
Next to save the settings and continue.
VO Vessel origin.
Jx Waterjet offset (Jet X offset).
Figure 21: Waterjet offset
This completes set up of the JETanchor control module. Set up of the full JETanchor system is not complete
until the JETanchor commissioning procedure has been completed (
►
page 5-28).