Hamilton Jet HTX30, Product Manual

Page: 121 / 182

HTX30 Product Manual Appendix
8-7
D-glide thrust washers
Loctite Colour Primer, activator, accelerator Loctite cure speed
325
Amber Type Drying time Partial Full
Activator 7387, or
Activator 7075
1-3 minutes 5 minutes 24 hours
D-glide thrust washer retention (high strength adhesive).
Use activator in all retaining applications.
Loctite 325 will not cure without the activator.
1 - Apply Activator to one side of thrust washer. Allow to dry.
2 - Apply Loctite evenly to housing recess.

Within 15 minutes, press thrust washer into recess, activator side to adhesive.

Remove any excess Loctite from the bush bore.
Hold the washer in place, for approx. 15 minutes, until the bond is firm.
Machine set screws, set screws, grub screws
Loctite Colour Primer, activator, accelerator Loctite cure speed
243
Blue Type Drying time Partial Full
Primer 7471 30-70 seconds With primer 10 minutes 2 hours
(optional) n/a Without primer 20 minutes 6 hours
222
Purple Primer 7471 30-70 seconds With primer 10 minutes 2 hours
(optional) n/a Without primer 20 minutes 6 hours
Machine screws, set screws, grub screws (low strength thread locking).
Use primer to shorten the cure time when the temperature is below 15°.
1 - Apply optional primer to the thread of the screw. Allow to dry. Screws fitted
into bronze do not require primer.
2 - Apply Loctite to the thread engagement area of the screw in sufficient
quantity to fill all engaged threads.
3 - Tighten screw to the specified torque. Find tightening torques for fasteners
here (
►
page 8-13).
Cylinder shafts, compensator shafts
Loctite Colour Primer, activator, accelerator Loctite cure speed
263
Red Type Drying time Partial Full
Primer 7649 30-70 seconds With primer 10 minutes 2 hours
(optional) n/a Without primer 20 minutes 6 hours
Cylinder shafts, compensator shafts (hydraulic, pneumatic thread sealant).
Use primer to shorten the cure time when the temperature is below 15°.
1 - Apply optional primer to the threads of the shafts Allow to dry.
2 - Apply Loctite to the female threads in the piston and to the threads on the
shafts in sufficient quantity to fill all the threads.
Assemble the shafts and piston as per the drawing specifications.