Foma N902iX, Manual

Page: 541 / 574

24
2
Click “
ダイヤル
” (Dial) and
execute access operation
You can leave user name and password blank
for the mopera U or mopera connection. If you
select an Internet service provider other than
mopera U, mopera or you use dial-up
connection, enter the “
ユーザー名 ” (User name)
and “ パスワード ” (Password) and click “ ダイヤ
ル ” (Dial).
Check “ パスワードを保存する ” (Save the
password) to skip entry of the password at
subsequent connections.
3
Check that the line is connected
properly, and click “OK”
Normally, this screen appears when the dial-up
connection is made.
This “
接続
” (Connection) message does not
appear if it has been set to be disabled.
d
During packet communication, a different icon appears on the FOMA terminal depending on the
communication conditions.
(Communicating, sending data)
(Communicating, receiving data)
(Communicating, no data transfer)
(Sending, or disconnecting)
(Receiving, or disconnecting)
d
appears on the FOMA terminal during 64K data communication.
NOTE
d
When executing data communication by using the FOMA USB Cable (optional), dialing from the dial-up icon is
only valid for the FOMA terminal used when the icon is created.
Therefore, to connect to another FOMA terminal, the communication setting file (drivers) must be installed
again.