Docomo P-07A Prime Series, Instruction Manual

Page: 70 / 617

68
Vo
ice
/V
id
e
o
pho
ne
Cal
ls
/P
u
sh
Ta
lk
1
m
1
Set./Service
1
Talk
1
Setting when closed
1
PushTalk
1
Speaker call or End the call
1
m
1
Set./Service
1
Talk
1
Volume
1
Use
B o
or
<
/
>
to
adjust the earpiece volume.
Adjust the earpiece volume to Level 1 (minimum) through Level 6 (maximum).
≥
You can adjust the volume by pressing
Z o
or
<
/
>
during a voice call and
calling,
B o
or
<
/
>
during a videophone call and PushTalk call, and by
pressing and holding
Z o
(for at least one second) while you are entering a
phone number. Press
B o
or
<
/
>
within two seconds to adjust it.
Set Response for when Closing FOMA Terminal during
PushTalk
Information
≥
This function is disabled when an earphone/microphone (option) is connected. The
communication state does not change even if you close the FOMA terminal during a
voice call or PushTalk call. However, if you close the FOMA terminal during a
videophone call, the substitute image is sent to the other party and the call continues.
≥
If you close the FOMA terminal during a videophone call with “No tone” set, the
substitute image is sent to the other party. When “Hold” is set, the still image set for
“Holding” of “Select image” is sent.
≥
Even when “End the call” has been set, the call does not end if you close your FOMA
terminal from Horizontal Open Style. “No tone” works for a voice call/videophone call,
and “Speaker call” works for a PushTalk call.
<Volume>
Adjusting Earpiece Volume
Information
≥
The earpiece volume adjusted during a call is retained even after the call ends.
≥
When you adjust the earpiece volume, the sound volume during a Hands-free call or
speaker call for PushTalk is also adjusted.
You can adjust the ring volume for incoming calls and mail.
1
m
1
Set./Service
1
Sound
1
Ring volume
1
Select an incoming type
1
Use
B o
to adjust the volume.
≥
The following icons are displayed on the Stand-by display while “Ring volume” is
set to “Silent”:
: Set for “Phone”, “PushTalk”, or “Videophone”.
: Set for “Mail”, “Chat mail”, “MessageR”, “MessageF”, or “i-concier”.
: Set for “Phone”, “PushTalk”, or “Videophone”, and for “Mail”, “Chat mail”,
“MessageR”, “MessageF”, or “i-concier”.
≥
If you have set “Step”, the ring tone is silent for about three seconds, and then the
volume steps up every three seconds, from Level 1 through Level 6.
≥
While the phone is ringing for a voice call or videophone call, you can adjust the
ring volume by pressing
B o
. However, you cannot adjust the ring volume in the
following cases:
・ When “Ring volume” is set to “Step”
・
When “Answer setting” is set to “Quick silent” and you stop the ring tone or
voice guidance
・ During Manner Mode
・
When a call is cut off within the ring start time specified by “Ring time”
+ m - 5 - 0
<Ring Volume>
Adjusting Ring Volume