Docomo P-07A Prime Series, Instruction Manual

Page: 609 / 617

44
※ The following commands do not result in an error even if specified; however, they do not function as commands.
≥
Command name: +CGDCONT=[parameter] [M]
･ Outline
This command sets an access point name (APN) for when dialing for packet communication.
･
Format
+CGDCONT=[<cid>[,"<PDP_type>"[,"<APN>"]]]
･ Explanation of parameters
You set an access point name (APN) for when dialing for packet communication. See the example below for command instructions.
<cid>
※
: 1 to 10
<PDP_type>: PPP or IP
<APN>
※ : Arbitrary
※
<cid> is a number used to manage an access point name (APN) for packet communication, which is registered in the FOMA terminal.
You can register 1 to 10 in the FOMA terminal. “mopera.ne.jp” is registered to <cid>=1 and “mopera.net” is registered to <cid>=3, each at purchase,
so register 2 or 4 through 10.
<APN> indicates any character string for each access point name.
･ Operation at omission of parameters
+CGDCONT=
: Sets all the <cid> contents to the default.
+CGDCONT=<cid> : Sets the specified <cid> to the default.
+CGDCONT=? : Lists the specifiable values.
+CGDCONT? : Displays the current setting.
･ Command execution example
AT+CGDCONT=2,"PPP","abc"
OK
※ The command used to register an APN name, abc (cid=2)
※
This command, which is a setting command, is not stored in the nonvolatile memory written by [&W], and is not reset by [&F] and [Z], either.
ATZn
[M]
Resets the setting to the
contents of the nonvolatile
memory. If this command is
entered during communication,
the line is disconnected. Only n=0 is specifiable. (Can be omitted) (In online)
ATZ
NO CARRIER
(In offline)
ATZ
OK
AT¥Sn
[M]
Displays the contents of the each
command and S register
currently set. Only n=0 is specifiable. (Can be omitted) AT¥S
E1 Q0 V1 X4 &C1
&D2 &S0 &E1 ¥V0
S000=000
S002=043
S003=013
S004=010
S005=008
S006=005
S007=060
S008=003
S010=001
S030=000
S103=000
S104=000
OK
AT¥Vn
[M]
[&F][&W] Selects the response code
specifications at connection. n=0: Does not use the extended result code. (default)
n=1: Uses the extended result code. AT¥V0
OK
･ AT (AT only entered.)
･ ATP (Pulse setting)
･
ATS8 (Setting the pause time by comma dialing)
･ ATT (Tone setting)
･ ATS6 (Setting the pause time taken for dialing)
･
ATS10 (Setting the automatic disconnection delay time)
Supplementary Explanation of AT Commands
AT command Outline Parameter/Explanation
Command execution
example
Continued to Next Page