Docomo P-07A Prime Series, Instruction Manual

Page: 319 / 617

317
Osai
fu-Kei
ta
i/
To
ruCa
You can start the Osaifu-Keitai compatible i-
α
ppli from the Software list.
By using Osaifu-Keitai compatible i-
α
ppli, you can read/write the data
inside the IC card and use convenient functions such as depositing
electronic money or checking your account for the balance and usage
details on the mobile phone.
≥
Take care of your Terminal Security Code and password used for each service not to
reveal to anyone.
≥
When you start or download the Osaifu-Keitai compatible i-
α
ppli program for the first
time, the message “Use IC card for current UIM?” appears. When you select “YES”,
you cannot use the IC card function afterward unless you insert the same UIM.
To use the IC card function with another UIM, delete all the information of the IC card
by “Change IC owner”, and then delete all the Osaifu-Keitai compatible i-
α
ppli
programs other than “ iD 設定アプリ (iD appli)”. Otherwise, you cannot use it.
≥
Reading and writing data from the software program and to the IC card is suspended in
the following cases:
In that case, the read or written data is discarded. The operation after the
communication ends differs depending on the service you use.
・
When a call comes in while an i-
α
ppli program is running
・ When the battery goes flat
1
m
1
Osaifu-Keitai
1
IC card content
The list of the Osaifu-Keitai compatible i-
α
ppli programs is displayed. When you
select an i-
α
ppli program, it starts up.
≥
See page 291 for the Software list.
<IC Card Content>
Starting Osaifu-Keitai Compatible i-
α
ppli
Read and Write Data inside the IC Card
Place the
f
mark of the FOMA terminal over the scanning device, and
you can use the FOMA terminal as electronic money to pay for shopping
or to use it as a traffic ticket. This function is available without starting
the software program.
≥
Even during a call or i-mode access, you can use Osaifu-Keitai by placing the
f
mark over the scanning device.
1
Place the
f
mark of the FOMA terminal over the
scanning device to use the target service.
≥
The Call/Charging indicator lights when you bring your FOMA terminal close to a
scanning device and communication becomes ready.
Use Osaifu-Keitai
Place the
f
mark of the FOMA
terminal over the scanning device.
Information
≥
Mount the battery pack to use Osaifu-Keitai. Even when the power is turned off or
when the battery has gone flat, you can use Osaifu-Keitai by placing the
f
mark
over the scanning device, however, you cannot start the Osaifu-Keitai compatible
i-
α
ppli. You might not be able to use Osaifu-Keitai if you have left the battery unused
for a long period or not charged it after the low battery alarm sounds. Charge the
battery.
≥
When the
f
mark of the FOMA terminal placed over the scanning device is not
identified, slightly move the mark forwards, backwards, to left, or to right.
≥
Osaifu-Keitai compatible i-
α
ppli might start when you place the FOMA terminal over
the scanning device.