Docomo P-07A Prime Series, Instruction Manual

Page: 247 / 617

245
Ca
mer
a
1
Finder display
1
i
( )
1
Auto timer
1
ON or OFF
1
Enter a delay time (seconds).
≥
Enter from “01” through “15”, in two digits.
“ ” appears on the Finder display.
If you press
O o
( ) or
v
, a confirmation tone sounds and “ ” blinks. When
“Flash setting” is set to other than “Always light ON”, the photo light flickers every about 1
second until about 5 seconds before shooting. From about 5 seconds before shooting,
the photo light flickers every about 0.5 second, and the confirmation tone sounds every
about 1 second. Shooting takes place after the set delay time has elapsed.
≥
To cancel shooting, press
l
( ) or
r
while the photo light is flickering. Even if
you cancel shooting, “Auto timer” stays set to “ON”.
≥
You can shoot immediately by pressing
O o
( ) or
v
before the delay time has
elapsed.
≥
When you shoot, a confirmation tone sounds regardless of the settings such as
Manner Mode. You cannot change the sound volume for the confirmation tone.
Auto Timer
At Camera start-up OFF
When Auto Timer is set to “ON”
Information
≥
You cannot use Auto timer in “Manual” of Continuous Mode.
≥
Auto timer is set to “OFF” when shooting ends.
You can use the outside camera to scan JAN codes and QR codes and
store them as data files. As to CODE 128, download a compatible i-
α
ppli
program and then scan the code to save the data. (See page 293)
From the scanned data, you can make calls, compose i-mode mail
messages, access Internet websites, and so on.
■
When scanning with Bar Code Reader
≥
Take the code as large as possible
within the guide frame.
≥
Autofocus works when you scan a
code about 10 cm or more away from
it. When you scan a code in the
out-of-focus state, the recognition
rate lowers.
≥
Scan so that the camera is in parallel
with the code.
■ JAN Code
JAN Code is a bar code that denotes numerals with
the vertical bars of a different width.
You can scan 8-digit (JAN8) and 13-digit (JAN13)
JAN codes.
≥
“4942857112597” is displayed when you scan this bar
code with the FOMA terminal.
■ QR Code
QR Code is one of the 2-dimensional codes that denotes data in
the vertical and horizontal directions.
Kanji, katakana, alphanumeric characters, and pictograms are
displayed when you scan it. Some QR codes have image or
melody information.
≥
“
株式会社NTTドコモ
(NTT DOCOMO, INC.)” is displayed when
you scan this QR code with the FOMA terminal.
<Bar Code Reader>
Using Bar Code Reader
Scanning Code display
Guide frame