Docomo P-07A Prime Series, Instruction Manual

Page: 242 / 617

240
Camera
You can shoot with the outside camera which focuses on a subject.
≥
When “Focus” is set to “Face detection”, faces are detected in the first place. When a
face is detected, the yellow frame is shown. Up to five faces are detected, and the
image is shot with a single face of them automatically focused according to the face
size and position. When multiple faces of people are found, the frame for a face to be
focused becomes yellow. When the detection fails, the focus function works in “Auto”.
≥
The focus function works when you shoot a subject about 10 cm or more away.
1
Finder display
1
X o
,
a
or
v
(halfway)
When a subject is focused, a focus lock tone sounds, the frame becomes green,
and the focus is locked.
When the subject is not focused, the frame becomes red.
≥
To cancel the focus locked by pressing
X o
or
a
, press
r
.
≥
When the focus is locked by pressing
v
(halfway), press
v
down for shooting.
Release
v
(halfway) to cancel the focus.
Use Focus Function
Information
≥
If “Movie type set” is set to “Voice” in Movie Mode, you cannot use the focus function.
≥
“Face detection” is available only in Photo Mode.
≥
Even when “Focus” is set to “Face detection”, you might not be able to detect the face
in the following cases:
・
When the face faces sideway or askew
・ When the face is at a slant
・ When part of the face is covered by glasses, a cap, or shadows
・
When the face is extremely small, large, or dim when compared to overall screen
size
・ When the face is placed at the edges of the display
≥
The distance that faces can be detected by “Face detection” is within about 2.5 m.
You can set whether to light the flash/photo light as a spare light for
when you use the outside camera to shoot in a dark place.
1
Finder display
1
i
( )
2
Flash setting
1
Select an operation of the flash/photo light to be set.
Auto. . . . . . . . . . . . . The flash automatically lights at intensity suitable for the
place.
Forced ON . . . . . . . The flash forcibly lights at the instant of shooting.
Always light ON. . . The photo light turns on.
Forced OFF . . . . . . The flash/photo light does not turn on at shooting.
Photo light set.
1
ON or OFF
≥
Even when “Flash setting” is set to “Always light ON” or “Photo light set.” is set to
“ON”, the photo light goes off when you show the Function menu or Post View
display.
Flash Setting/Photo Light Setting
At Camera start-up Photo light set.: OFF
In Photo Mode
In Continuous/Movie Mode
Information
≥
You cannot set “Flash setting” to “Forced ON” when “Photo mode” is set to “intelligent
Auto”.
≥
When the battery is almost empty, “Flash setting” is set to “Forced OFF”, and “Photo
light set.” is set to “OFF”.
≥
When you terminate the camera session or you switch to the inside camera while
“Flash setting” is set to other than “Forced OFF”, “Flash setting” is set to “Auto” when
you start the camera next time or you switch back to the outside camera. When “Flash
setting” is set to “Forced OFF”, the setting is retained. However, if you set to “Forced
OFF” when the battery is almost empty, the setting is not retained.
≥
The appropriate shooting distance when using flash is from about 40 to 100 cm.