Digimerge DH200+R Series, Instruction Manual

Page: 60 / 176

48
Using the Main Menu
ALARM
The ALARM tab allows you to configure the
system Alarm Buzzer and Alarm Input type on
each channel (i.e. N.O and N.C (normally open
and normally closed) settings)).
1. Configure the following in the Alarm tab:
• INPUT: Select the alarm type connected to
the particular channel. Select from N.O. or
N.C. (Normally Open, or Normally Closed).
• OUTPUT: Select N.O. (Normally Open) or
N.C. (Normally Closed). Under INACTIVE,
select the event type (Manual or Event).
• BUZZER: Select ON/OFF . Under INACTIVE,
select the event type (Manual or Event).
• CONTROL: Turn the OUTPUT/ BUZZER on
or off. To enable the ON button, under
INACTIVE select
MANUAL .
2. Click ENTER
(
) to save your settings.
3. Click the EDIT EVENT icon( ) beside
OUTPUT/BUZZER to configure the actions
that follow when an alarm output occurs /
buzzer. The alarm output must be set to
N.C or N.O before you can access the Edit
Event window.
Edit Event icon
4. Configure the following in the EVENT EDIT
(ALARM OUT 1) Window:
• ALARM IN : Select the other alarms that
will also trigger when Alarm OUT 1/
BUZZER activates.
• MOTION : Select the cameras that will
cause ALARM OUT 1/BUZZER to activate
when motion is detected.
• VLOSS : Select the cameras that will cause
ALARM OUT1/BUZZER to activate when
video loss occurs in one of the cameras.
• SYSTEM : Select the events that will cause
ALARM OUT 1/BUZZER to activate.
5. Click ENTER
(
) to save your settings.
Press CANCEL/ESC to close remaining
menu windows.