Digimerge DH200+R Series, Instruction Manual

Page: 39 / 176

27
Setting up Sequencing
Event View
Event view allows the channel that detects an event (i.e. motion or alarm) to appear in the main
channel. This is especially useful if you set up sequence in single-channel view, but want to see
immediately any channels that detect motion.
To set up Event sequence mode:
1. Press the MENU button on the remote or front panel to open the main menu.
• If using a mouse, right-click to open the virtual remote, then click MENU .
2. Click DISPLAY .
Display
3. Click the SWITCH tab.
Switch
4. Beside DEVICE, select MAIN or SPOT .
5. Configure the following:
• MODE : Select EVENT .
• SPLIT MODE (MAIN configuration only): Select the desired split-screen style.
• USE CHANNEL : Select the channels you want to view.
6. Click the EVENT tab.
Ensure that the number
under MOTION matches
the channel number.
7. In the MOTION column, ensure the number matches the channel number as shown in the
image above. For example, Channel 1 will have a Motion value of 1 etc.
8. Click ENTER
(
) .