147
Appendix G: Connecting Motion / Alarm Devices
APPENDIX G: CONNECTING MOTION / ALARM
DEVICES
You can enable motion detection and alarm control from the Main Menu. You can also connect
additional motion sensor devices to the system (i.e. motion sensors, door/window sensors). Use
a motion detector or sensor to send a signal to the system to begin camera viewing and recording
on the matching camera channel (when enabled in the Menu).
To connect an external alarm sensor (ALARM INPUT) to the system:
1. Connect the Signal Cable to the desired
port
in the alarm block.
2. Connect the Ground cable to the
Ground port (G)
in the alarm block.
3. Open the MAIN MENU and select
DEVICE>ALARM
.
4. Select the corresponding alarm channel and select
INPUT
.
5. Select
N.C.
(Normally closed) or
N.O.
(normally open) depending on your alarm/sensor setup.
6. Press the
ENTER
button to save your settings.
ALARM or SENSOR
(Not Included)
Ground
Summary of Contents for DH200+R Series
Page 12: ...xii...
Page 119: ...107 iSMS Client Remote Viewing on the Mac PTZ Controls cont d...
Page 174: ......
Page 175: ......
