Selection number
Selection name
Description
0
No Action
No response
1
Alarm
Warnings, warning levels S1 and S2 are used
2
Fault
Fault + Warnings, warning S1, warning S2, and alarm/fault levels are used
10.573 (ID 3541) Current Warning S1 Counter
Location in the menu:
P2.13.3.5.1
(Multi-purpose Control Application)
Use this parameter to set warning S1 counter value.
10.574 (ID 3542) Current Warning S2 Counter
Location in the menu:
P2.13.3.5.2
(Multi-purpose Control Application)
Use this parameter to set warning S2 counter value.
10.575 (ID 3543) Current Alarm/Fault Counter
Location in the menu:
P2.13.3.5.3
(Multi-purpose Control Application)
Use this parameter to set alarm/fault counter value.
10.576 (ID 3546) Voltage Warning S1 Counter
Location in the menu:
P2.13.3.8.1
(Multi-purpose Control Application)
Use this parameter to set warning S1 counter value.
10.577 (ID 3547) Voltage Warning S2 Counter
Location in the menu:
P2.13.3.8.2
(Multi-purpose Control Application)
Use this parameter to set warning S2 counter value.
10.578 (ID 3548) Voltage Alarm/Fault Counter
Location in the menu:
P2.13.3.8.3
(Multi-purpose Control Application)
Use this parameter to set alarm/fault counter value.
10.579 (ID 3549) Stop Counter Delay
Location in the menu:
P2.13.3.5.4, P2.13.3.8.4, P2.13.4.4.4 and P2.13.5.3.4
(Multi-purpose Control Application)
Use this parameter to set stop counter. The counter is stopped if threshold value is outside of the limit below this time.
10.580 (ID 3550) Vibration Mean Factor
Location in the menu:
P2.13.4.2.1
(Multi-purpose Control Application)
The several statistical data points (mean, minimum, maximum, and standard) from the baseline model can be combined into one
threshold value. Use this parameter to set the mean factor in the threshold value. If the threshold value is zero, the mean factor is
not used.
See the formula in
10.544 (ID 3511) Current Mean Factor
.
10.581 (ID 3551) Vibration Min Factor
Location in the menu:
P2.13.4.2.2
(Multi-purpose Control Application)
The several statistical data points (mean, minimum, maximum, and standard) from the baseline model can be combined into one
threshold value. Use this parameter to set the min factor in the threshold value. If the threshold value is zero, the min factor is not
used.
See the formula in
10.544 (ID 3511) Current Mean Factor
.
10.582 (ID 3552) Vibration Max Factor
Location in the menu:
P2.13.4.2.3
(Multi-purpose Control Application)
AB296635287482en-000301 / DPD00903
300 | Danfoss A/S © 2023.02
Parameter Descriptions
VACON® NX All-in-One
Application Guide
Summary of Contents for VACON NX
Page 1: ...Application Guide VACON NX All in One drives danfoss com...
Page 2: ......
