Danfoss VACON NX, Application Manual

Page: 110 / 360

Index Parameter Min Max Unit Default ID Description
1 = Torque memory
2 = Torque reference
3 = Start-up torque fwd/rev
P2.6.15.12 Start-up torque FWD -300.0 300.0 s 0.0 633
-
P2.6.15.13 Start-up torque REV -300.0 300.0 s 0.0 634
-
P2.6.15.15 Encoder filter time 0.0 100.0 ms 0.0 618
-
P2.6.15.17 Current control P gain 0.0 320.0 % 40.0 617
-
P2.6.15.18 CurrentControl- Time 0.0 320.0 ms 1.5 657
-
P2.6.15.19 Generator power limit 0.0 300.0 % 300.0 1290
-
P2.6.15.20 Motoring power limit 0.0 300.0 % 300.0 1289
-
P2.6.15.21 Negative torque limit 0.0 300.0 % 300.0 645
-
P2.6.15.22 Positive torque limit 0.0 300.0 % 300.0 646
-
P2.6.15.23 Flux off delay -1 32000 s 0 1402
-
P2.6.15.24 Stop state flux 0.0 150.00 % 100.00 1401
-
P2.6.15.25 SPC f1 point 0.00 320.00 Hz 0.00 1301
-
P2.6.15.26 SPC f0 point 0.00 320.00 Hz 0.00 1300
-
P2.6.15.27 SPC Kp f0 0 1000 % 100 1299
-
P2.6.15.28 SPC Kp FWP 0 1000 % 100 1298
-
P2.6.15.29 SPC torque minimum 0.0 400.0 % 0.0 1296
-
P2.6.15.30 SPC torque minimum Kp 0 1000 % 100 1295
-
P2.6.15.31 SPC Kp TC torque 0 1000 ms 0 1297
-
P2.6.15.32 Flux reference 0.0 500.0 % 100.0 1250
-
P2.6.15.33 Speed error filter TC 0 1000 ms 0 1311
-
P2.6.15.34 Modulation limit 0 150 % 100 655
-
Table 78: PMS Motor Control Parameters, G2.6.16
Index Parameter Min Max Unit Default ID Description
P2.6.16.1
Motor type 0 1
-
0 650 0 = Induction Motor
AB296635287482en-000301 / DPD00903 110 | Danfoss A/S © 2023.02
Multi-purpose Control Application
VACON® NX All-in-One
Application Guide