ComAp InteliLite AMF25, Global Manual

Page: 143 / 735

InteliLite Global Guide
143
start Start the engine in MAN mode.
stop Stop the engine in MAN mode.
fault reset Acknowledging alarms and deactivating the horn output.
gcb close Closing GCB in MAN and TEST mode.
gcb open Opening GCB in MAN and TEST mode.
off Switching to OFF mode.
man Switching to MAN mode.
auto Switching to AUTO mode.
status Get status information from controller unit.
help Get a list of available SMS requests.
Note: Between commands are internal delays adjusted due to system requirements.
Example: When the controller, in AUTO mode, with a controller name of “InteliLite-Test”, with the CM-
GPRS module and access code “0” receives the SMS:
0 man, start, gcb close, gcb open, stop, auto
Controller mode will be changed to MANUAL mode. The engine will be started and GCB will close. Then
GCB will open, the engine will stop and it will go into AUTO mode again.
The controller will send back the SMS (controller will respond to SMS after every command has been
finished, not sooner.):
#InteliLite-Test: <OK>,<OK>,<OK>, <OK>,<OK>, <OK>
The value <OK> or <ERROR> means if the command has been performed succesfuly or not.
Emails
Event Email
The InteliLite controller equipped with the CM-Ethernet communication module is able to send Event Email
according to the setting of setpoint:
Event Message (page 374)
Note: Firstly setpoints Email Address 1 (page 371) and SMTP Sender Address (page 365) (for CM-GPRS)
or SMTP Sender Address (page 377) (for CM-Ethernet) have to be adjusted.
Note: #Summer Time Mode (page 302) and Time Zone (page 374) have to be adjusted for correct time in
emails.