ComAp InteliLite AMF25, Global Manual

Page: 526 / 735

InteliLite Global Guide
526
LBI: D
Related FW 1.9.0 Related applications AMF, MRS
Comm object 930
Description
This binary input activates function of dark mode. It means that backlight of display is turn of (information on
controller screens are not affected) and LEDs (Mains, Generator, Load, Breakers, etc.) are turn off (LEDs
don’t react on normal condition of their activation and deactivation).
Note: After deactivation of dark mode, backlight of display is turned on and than behaves normally.
Note: After deactivation of dark mode, Front Face status LEDs are turned on due to current situation of
gen-set.
Dark Mode
6
back to Logical binary inputs alphabetically
Related FW 1.9.0 Related applications AMF, MRS
Comm object 947
Description
This LBI enables or disables swapping of gen-sets on load in dual operation. This LBI has higher priority then
setpoint Swap Gen-sets (page 240) . This LBI is accepted only in Master controller.
Dual Swap Gen-sets
6
back to Logical binary inputs alphabetically
Related FW 1.9.0 Related applications AMF, MRS
Comm object 954
Description
This LBI defines, which gen-set has higher priority in dual operation mode. If this LBI is active on one gen-
set, this gen-set is used in dual operation function (running hours values are not used to decide, which gen-
set should start).
Setpoint Swap Gen-sets (page 240) or LBI D
UAL
S
WAP
G
EN
-
SETS
(
PAGE
526) has higher priority than this
LBI.
Example: Engine 1 is running. LBI Top Priority is activated on engine 2. If swapping of gen-sets is
disabled, nothing happens. If swapping of gen-sets is enabled, engine 2 is started and engine 1 is
stopped.
Note: If this LBI is active on both gen-sets, the behavior is not changed. Decision is based on running
hours values.
Dual Top Priority
6
back to Logical binary inputs alphabetically