BECKWITH ELECTRIC M-6280A, Instruction Book

Page: 368 / 462

6–5
Testing –6
6.4 Button Test
Front Panel Pushbutton Testing
To test the control front panel pushbuttons proceed
as follows:
1. Press the "ENT" (UTIL Hot Button)
pushbutton to awaken the unit. The
menu will advance to "UTILITIES".
UTILITIES

COMM MNTR

2. Press the Down Arrow pushbutton once.
The unit will display the following:
Calibration/Test
 
3. Press the Down arrow pushbutton as
necessary to navigate to the Button Input
Test menu item.
Button Input Test
Press ENT to Begin
4. Press the "ENT" pushbutton. If Level
2 Access is not active or has been
previously input, then the following will
be displayed. Go to Step 7.
Button Input Test
00000000
5. If Level 2 Access is active, then the
Level 2 Access prompt will be displayed.
ENTER LEVEL 2 ACCESS
_

NOTE: When entering the Level 2 Access code
the display will automatically advance
the cursor to the next digit when input
is momentarily paused.
6. Enter a valid Level 2 Access code, then
press the "ENT" pushbutton.
If a valid Level 2 Access code was
entered, then the display will briefly flash
a confirmation screen and then display
the following:
Button Input Test
00000000
If not, re-enter a valid code.

NOTE: The following key identifies each
pushbutton position from left to right:
Position Pushbutton
1 N/A
2 N/A
3 ENT/UTIL
4

/COMM
5

/CNFG
6

/SETP
7

/MNTR
8 EXIT/WAKE
7. Test the desired pushbutton by pressing
and holding the pushbutton. The display
will change from a "0" to "1" if the
pushbutton is working correctly.