BECKWITH ELECTRIC M-6280A, Instruction Book

Page: 250 / 462

Configuration – 4
4–59
Setting Programmable Alarm Relay Inputs
From The HMI
Each alarm condition (Figure 4-39) corresponds to
one of eleven digits on the bottom line of the display:
a "0" indicates that the alarm condition is disabled;
a "1" indicates that the alarm condition is enabled.
To set the Programmable Alarm perform the
following:
1. Press the Down Arrow (CNFG Hot Button)
pushbutton to awaken the unit. The menu
will advance to "CONFIGURATION".
CONFIGURATION

SETP COMM

2. Press the Down Arrow pushbutton once.
The unit will display the following:
Cap Settings
 
3. Press the Right or Left Arrow pushbutton
as necessary until "Programmable
Alarm" is displayed.
Programmable Alarm
 
4. Press the Down Arrow as necessary until
the following is displayed.
Prog Alarm Function
00000000000000
5. Press the "ENT" pushbutton. If Level
2 Access is not active or has been
previously input, then the following will
be displayed. Go to Step 8.
max. volt limit
00000000000000 C
6. If Level 2 Access is active, then the Level
2 Access prompt will be displayed.
ENTER LEVEL 2 ACCESS
_

NOTE
: When entering the Level 2 Access Code
the display will automatically advance
the cursor to the next digit when input
is momentarily paused.
7. Enter a valid Level 2 Access Code, then
press the "ENT" pushbutton.
If a valid Level 2 Access Code was
entered, then the display will briefly flash
a confirmation screen and then display
the following:
max. volt limit
00000000000000 C
If not, re-enter a valid code.

NOTE : See Figure 4-35 for the index of alarm
functions.
8. Utilizing the Right and Left arrow
pushbuttons, navigate to the desired
Alarm Function (Figure 4-39).
9. Utilizing the arrow pushbuttons enter
a "1" for those Alarm Functions to be
activated and a "0" for those that are
to be disabled, then press the "ENT"
pushbutton. The following will be
displayed reflecting the selections that
were made.
Prog Alarm Function
00000000000000