BECKWITH ELECTRIC M-6280A, Instruction Book

Page: 121 / 462

2–62
M-6280A Instruction Book
Setting the Active Setpoint Profile (HMI)
To set the Active Setpoint Profile from the HMI
perform the following:
1. Press the Up Arrow (SETP Hot Button)
pushbutton to awaken the unit. The
menu will advance to “SETPOINTS”.
SETPOINTS
W
MNTR CNFG
V
2. Press the Down Arrow pushbutton once.
The unit will display the following:
Profile Settings
W V
3. Press the Down Arrow pushbutton
as necessary until “Active Profile” is
displayed.
Active Profile
x

NOTE: If a Profile Trigger is Active the control
will display a “Disable Active Trigger to
Edit” message.
4. Press the “ENT” pushbutton. If Level
2 Access is not active or has been
previously input, the following will be
displayed. Go to Step 7.
Active Profile
x
C
5. If Level Access is active, the Level
Access prompt will be displayed.
ENTER ACCESS CODE
_

NOTE: When entering the Level 2 Access code
the display will automatically advance
the cursor to the next digit when input
is momentarily paused.
6. Enter a valid Level 1 or 2 Access code,
then press the “ENT” pushbutton.
If a valid Level 2 Access code was
entered, the display will briefly flash a
confirmation screen, and then display
the following:
Active Profile
x
C
If not, re-enter a valid code.
▲ CAUTION: The control will immediately respond
to the new Active Setpoint Profile settings.
7. Utilizing the arrow pushbuttons select the
desired Profile to activate, then press the
“ENT” pushbutton. The desired Setpoint
Profile will be displayed.
Active Profile
1 to 8