Balluff BVS ID-M1280 F1 Series, Configuration Manual

Page: 252 / 316

BVS ID-M1280xF1-xx-xxx
94 english
•
•
•
•
4.3.5.1 Set Inspection ID
This command sets the active inspection program in the BVS ID is switched over. The inspection program
number (ID) is set in the SensorApp.
Command:
Sub address Data Meaning
n+00 0x02 1st bit string (Job Start)
n+01 0x01 Set Inspection ID
n+02 0x04 User data length byte 0
n+03 0x00 User data length byte 1
n+04 Inspection ID byte 0
n+05 Inspection ID byte 1
n+06 Inspection ID byte 2
n+07 Inspection ID byte 3
…
n+31 0x02 2nd bit string
Response:
Sub address Data Meaning
n+00 Status byte
n+01 Error byte
n+02 0x02 1st bit strip (Job Start)
n+03
CMD status:
0x00 Command was executed successfully
0x16
Command could not be executed because another command was still being processed or is
not yet ready after a restart.
0x1A
The inspection program could not be changed. The following error causes are possible:
It is not possible to switch to an inspection program with ID 0 via the communication
interface.
The inspection program with the requested ID does not exist.
The maximum number of inspection programs has been exceeded. An inspection
program change is only possible again when the number of inspection programs
has been reduced to a maximum of 16.
Fatal error: The inspection program may have been damaged or there is too little
memory (RAM) to load the new inspection program.
n+04 0x00 User data length byte 0
n+05 0x00 User data length byte 1
…
n+31 0x02 2nd bit string