Balluff BVS ID-M1280 F1 Series, Configuration Manual

Page: 182 / 316

BVS ID-M1280xF1-xx-xxx
24 english
2.3.2 Configure
You can use Configure to create inspection programs.
Menu item Meaning
The program takes images continuously and runs through to the selected program step ("Loop"). If trigger mode
Rising edge has been selected in Inputs, it is waiting for a trigger event.
Emits a trigger if the Loop is activated and a trigger event is waited for. This causes an image to be acquired.
Performs a single iteration if the Loop is not activated. This also causes an image acquisition.
Auto Setup With this button you can start the Auto Setup process .
Tools
An inspection consists of 3 elements: Inputs, Analysis, and Outputs. These tools are described in the following
chapter.
With the save button you can save the current state of the inspection.
NOTE
The Auto Setup process search for codes independently from the configuration in Analysis. The Auto
Setup then tries to validate the found code based on the set Timeout and Reader Mode. After
successful validation, the code type gets set in Analysis, otherwise the settings might need to be
adjusted.
