Balluff BVS ID-M1280 F1 Series, Configuration Manual

Page: 305 / 316

BVS ID-M1280xF1-xx-xxx
english 147
4.4.9.15 LED Meaning and Configuration
Description
Only the signal with the highest priority is displayed. The signals are listed in descending priority.
Balluff Standard (LED 1 - IO-Link)
Name Signal Meaning
Device Discovery Blue, flashing 3 Hz
The Device Discovery can be activated via a
system command to find the BVS ID again.
Short Circuit Pin 2 / Pin 4 Red, flashing 3 Hz
Short circuit at pin 2 (I/O Trigger) or pin 4 (IO-Link /
SIO).
Teach-in No Object Red, flashing 1 Hz No code was found during auto setup.
Failure Red, static General error. The sensor is not ready.
Teach-In Red, static
The BVS ID is currently in teach-in mode (e.g.
teach-in of inclination detection)
Maintenance Required Blue, static
Maintenance must be performed.
E.g. threshold of the inclination is exceeded
(default: function is switched off).
Overload Orange, flashing 3 Hz
Overload on pin 2 (I/O Trigger) or pin 4 (IO-Link /
SIO) has been detected.
Bad Signal Quality Orange, flashing 1 Hz
Poor signal quality, the quality of one code or
several codes is below the configured warning
threshold.
Out of Specification Yellow, flashing 3 Hz
The BVS ID e is operated outside of specifications.
A reliable measurement signal can no longer be
ensured.
Communication
Green, alternating with LED off in a ratio of
10:1, 1 s period
IO-Link communication is active. The BVS ID is
ready.
Ready Green, static The BVS ID is ready.
Firmware Update LED off The IO-Link firmware is updated.