Balluff BVS ID-M1280 F1 Series, Configuration Manual

Page: 221 / 316

BVS ID-M1280xF1-xx-xxx
english 63
4.1.5.9 Trigger inspection
It is sent from the client to start an inspection pass. The behavior depends on the setting in the BVS ID . If an
inspection is untriggered, this message is being ignored. To check whether the device is ready to receive a
trigger, the
Waiting For Trigger bit of the status message may be evaluated .
Length in bytes Structure Value Description
2 UINT16
40
hex
Message ID
2 UINT16
00
hex
User data length in bytes
BVS ID answers with the following response message:
Length in bytes Structure Value Description
2 UINT16
40hex
Message ID
2 UINT16
02
hex
User data length in bytes
2 UINT16 Result code
Example:
Message from the client to BVS ID : 40 00 00 00
BVS ID responds to it with: 40 00 02 00 00 00
4.1.6 Testing the communication
4.1.6.1 Under Linux
For testing the UDP communication you can use the tool Netcat under Linux. The following console prompts
will open a connection, trigger the current inspection, and close the connection.
In this example the IP address is 192.168.1.230. The port 60001 is used to get results.
# Connect
echo -n -e '\x01\x00\x00\x00' | nc -uw 1 -p 60001 192.168.1.230 36701
# Trigger inspection:
echo -n -e '\x40\x00\x00\x00' | nc -uw 1 -p 60001 192.168.1.230 36701
# Disconnect:
echo -n -e '\x02\x00\x00\x00' | nc -uw 1 -p 60001 192.168.1.230 36701
NOTE
The Trigger inspection command will capture a single image only if the trigger mode is configured to
edge in the tool Inputs .
