Balluff BVS ID-M1280 F1 Series, Configuration Manual

Page: 303 / 316

BVS ID-M1280xF1-xx-xxx
english 145
4.4.9.13 Reset Commands
The device supports various reset commands for resetting the set parameters to default values. Each of these
commands is accessed by means of System Commands.
This function is defined in the IO-Link specification and is implemented according to Version 1.1.2.
ISDU
Name Index
Subinde
x
Acces
s
Length Data Type
Data
Storage
Default
System Commands
0x0002
(2)
0 W 1 byte UINT8 n/a -
System Commands
Command Value Device Action
0x80 (128)
Device Reset – Device Reset means a warm start of the BVS ID. During this process, the
microcontrollers are restarted, and all initializations performed again without any change made to the
parameter values.
0x81 (129)
Application Reset – This reset is performed using IO-Link specification V1.1.2.
– Resets all parameters and device settings to default values (except for the
identification and tagging parameters)
– No reset of the configuration of the device variant
– Set DS-upload request (accept the data in the memory)
– No communication stop or restart
0x82 (130)
Reset Factory Settings – This reset is performed using IO-Link specification V1.1.2.
– Reset all parameters and device settings to default settings (including identification and
tagging parameters)
– Reset the configuration of the device variants to the default variant
– No DS-upload request
– No communication stop or restart
0xA5 (165)
Maintenance Reset – Resets all resettable maintenance and service life parameters for the user so that the
next maintenance cycle can begin