Balluff BVS ID-M1280 F1 Series, Configuration Manual

Page: 267 / 316

BVS ID-M1280xF1-xx-xxx
english 109
Event Code Event Type Event – Description – Remedy Device Status
0x8D0E (36110) Notification
The time has elapsed. This event
reports the timeout of the minimum
value/maximum value/average
calculation.
It does not report a timeout for the
calculation of the moving average
because the timer repeats, and it
does not indicate the end of the
calculation.
0 – Device is operating properly.
0x8D10 (36112) Warning
Device Temperature Upper Warning –
The set upper temperature warning
threshold has been exceeded.
0 – Device is operating properly.
0x8D12 (36114) Warning
Exceedance of the set threshold of
the equipment internal humidity.
→ check installation and ambient
conditions.
1 – Maintenance-Required
0x8D13 (36115) Warning
One or more extreme conditions
present.
0 – Device is operating properly.
0x8D15 (36117) Warning
Overload at pin 2
→ check cabling.
2 – Out-of-Specification
0x8D20 (36128) Warning
Device Temperature Lower Warning –
The device temperature has fallen
below the set lower temperature
warning threshold.
0 – Device is operating properly.
0x8D22 (36130) Warning
Warning limit for write cycles reached
– maintenance monitoring no longer
guaranteed – for information purposes
only.
0 – Device is operating properly.
0x8D23 (36131) Error
Write cycle limit reached – saving no
longer ensured – replacement
recommended.
1 – Maintenance-Required
0x8D24 (36132) Warning
Parameter write error – for information
purposes only.
0 – Device is operating properly.
0x8D25 (36133) Error
Parameters not consistent – basic
settings are used, service required.
Parameterization processes and
resets can no longer be performed.
4 – Failure
0x8DC0 (36288) Notification
Teach-in Timeout – The current
teach-in process took too long an
was terminated.
0 – Device is operating properly.