URAL Motorcycles 4320M, Руководство по эксплуатации, Страница: 291 / 321

256
APPENDICES
APPENDIX A
(recommended)
Table A.1 - Torques of Basic Screw Joints Nm (kgfm)
A.1 Engine
Retaining nuts:
of the muffler 24 -36 (2.4-3.6)
of the headpipe to discharge manifold collar 28 -36 (2.8-3.6)
of power unit support to the girder 78 -98 (8-10)
of rear brackets to the support 270 -340 (27-34)
of front supports 110 -140 (11-14)
Fixing bolts of
front brackets to the power unit 49 -61 (5-6.2)
rear brackets to the power unit 270 -340 (27-34)
125 mm air feed system worm drive clamps 5 -6 (0.5-0.6)
90 mm air feed system
worm drive clamps
3 -3.5 (0.3-0.35)
V-shape clamps f fastening the gas exhaust system metal pipe 12 (1.2)
Muffler fastening clamp nuts 27.5 -35.3 (2.8-3.6)
A.2 Transmission
Clutch Master Cylinder Bolts M12 44 -56 (4.4-5.6)
A.2.1 Transfer Box
Retaining nuts of main shaft, lay shaft and rear differential cage bearings, min-
imum
200 (20)
Transfer box flanges retaining nuts, minimum 200 (20)
Fixing bolts of:
differential nut 24 -36 (2.4-3.6)
rear differential cage 55 -65 (5.5-6.5)
main and lay shaft bearing caps 40 -56 (4.0-5.6)
rear differential bearing crankcase 44 -62 (4.4-6.2)
rear axle drive shaft bearing cap 40 -56 (4.0-5.6)
front axle drive shaft bearings cap 30 -35 (3.0-3.5)
oil-level plugs
МК24х1.5 100 -140 (10-14)
K 3/8” 80-120 (8-12)
*1
drain plug 100 -140 (10-14)
A.2.2 Driveline
Fixing bolt nuts:
of the intermediate axle drive prop shaft and the lay prop shaft flanges
160 -200 (16-20)
of the front and rear axle prop shaft flanges 120 -160 (12-16)
of the intermediate support and insert 180 -220 (18-22)
A.2.3 Driving Axles
Fixing bolts of:
the main gear to the axle case
М16 160-200 (16-20)
*2
М18 190 -230 (19-23)